09 1724 100 12 | binder Snap-In Female panel mount connector, Contacts: 12, unshielded, solder, IP54

Menu

Menu

Products
Connectors for medical applications
ELC
Snap-In Female panel mount connector, Contacts: 12, unshielded, solder, IP54

Illustration 09 1724 100 12 - Snap-In Female panel mount connector, Contacts: 12, unshielded, solder, IP54 — Illustration

Component part drawing 09 1724 100 12 - Snap-In Female panel mount connector, Contacts: 12, unshielded, solder, IP54 — Component part drawing

Scale drawing 09 1724 100 12 - Snap-In Female panel mount connector, Contacts: 12, unshielded, solder, IP54 — Scale drawing

Assembly instructions / Panel cut-out 09 1724 100 12 - Snap-In Female panel mount connector, Contacts: 12, unshielded, solder, IP54 — Assembly instructions / Panel cut-out

Part no.	09 1724 100 12
Connector design	Female panel mount connector
Version	Connector socket straight
Connector locking system	snap-in
Termination	solder
Degree of protection	IP54
Cross-sectional area	max. 0.25 mm² / AWG 24
Temperature range from/to	-25 °C / 85 °C
Mechanical operation	> 5000 Mating cycles
Weight (g)	7.90
Customs tariff number	85369010
Country of Origin	DE

Rated voltage	150 V
Rated impulse voltage	1500 V
Rated current	2.0 A
Insulation resistance	≥ 10¹⁰ Ω
Pollution degree	2
Overvoltage category	II
Insulating material group	II
EMC compliance	unshielded

Housing material	PA
Contact body material	PA
Contact material	CuZn (brass)
Contact plating	Au (gold)
REACH SVHC	CAS 7439-92-1 (Lead)
SCIP number	14b60057-66cf-49ed-8786-36978d5583a7

Low Voltage Directive	2014/35/EU (EN 60204-1:2018;EN 60529:1991)
RoHS Directive	2011/65/EU (EN 50581:2012)

Report error on this page

Security notices

The connector must not be plugged or unplugged under load. Non-observance and improper use can result in personal injury.
The connectors have been developed for applications in plant engineering, control and electrical equipment construction. The user is responsible for checking whether the connectors can also be used in other areas of application.
Connectors which are used in circuits with voltages dangerous to the touch may only be installed and used by, or under the supervision of, persons with electrical engineering training, taking into account the applicable regulations and standards.
The user must take suitable safety precautions to ensure that the connector cannot be accidentally disconnected.
Plug connectors with enclosure protection IP67 and IP68 are not suitable for use under water. When used outdoors, the plug connectors must be protected separately against corrosion. For further information on the IP protection classes, please refer to the "Technical Information" download centre.
The plug connector is not suitable for mains voltages Please observe the pollution degree and the overvoltage category. For further information, please refer to the download center "Technical Information".
To lock the cable connector to the device connector, we recommend tightening the threaded ring to 1 Nm. A suitable torque wrench is available as an accessory (order no. 07 0082 000).

Downloads

Data sheet 09 1724 100 12

Declaration of conformity

Low Voltage Directive

UKCA declaration of conformity

Electrical Equipment

Declaration of conformity

UKCA declaration of conformity

STP-Data 09 1724 100 12